Loose Denali Light Mount Fitting 1200GS

[stirtloe]

Fitting the Denali Light Mount to a 2011 R1200GS. (Thank you Nippy Normans)

Installation consists of attaching a bar to 2 x U-Bolts over subframe behind the oil cooler.

2 sets of U Bolts are supplied one for the GS one for GSA. I have attached the correct ones.

The bar is secure on the U Bolts but the mount is still loose and can move.

I can secure it using plastic ties but would prefer a better solution if anyone has one.

 

[waggy]

I have the same bar and it is fixed nice tight for me. The diagram shows a nut either side of the bar but I only used one under the bar if you know what I mean. The only issue I had was the first time I fitted it was to trap an indicator cable so make sure that is not the case!!
If I can help further please let me know

 

[stirtloe]

Thank you I'll try it, that will work as the top nut is the one preventing the bar getting flush with the subframe.

 

[waggy]

Let me know how you get on please

 

[DJ123]

If you have a slim rubber sheet, or some anti slip matting, you could use that to fill the gap/create a gripping point for it? (unless the gap/looseness is fairly large)

 

[stirtloe]

Thanks for the suggestions bar fitted and all good, no top nut and I put anti slip tape on it as well.