electric_monk
Registered user
Has anyone used a scala rider with the BMW enduro helmet?
Does anyone know if ti fits on OK?
Does anyone know if ti fits on OK?
Scala and enduro helmet
- Thread starter electric_monk
- Start date
electric_monk
Registered user
Cheers mate that's what I was hoping to hear.
you may need better adhesive to keep the velcro in place for the speakers - I used hot melt in the end and it's not moved since !!!
Snowman
Snowman
electric_monk
Registered user
I was just coming back to this thread to ask that very question...what is this hot melt you mention?
steve g
Registered user
Works OK for me. Mind you it took 3 attempts to get the speakers in the correct position for optimum sound. Works better than I though especially with my Ipod plugged directly in.
GS_or_bust
Registered user
Cut the lining.
I cut a small slot in the material cover of each cheek pad covering material round the back where it wouldn't be seen and slid the speakers between the material and the cheek pad forward of the strap hole. That way you don't even feel them. I also cut the bracket slightly because there wasn't much room between the shell and the lining edge for the bracket clamp.
The microphone sits nicely in the chin guard above the wind shield.
I cut a small slot in the material cover of each cheek pad covering material round the back where it wouldn't be seen and slid the speakers between the material and the cheek pad forward of the strap hole. That way you don't even feel them. I also cut the bracket slightly because there wasn't much room between the shell and the lining edge for the bracket clamp.
The microphone sits nicely in the chin guard above the wind shield.
Hot melt Glue from an electric Glue Gun
Snowman
Snowman
Similar threads
