R1200 GS. 2006 taken off cir-clip removed bolt and switch . Bearing /bush will rotate but cannot pull out . Any advice please.
thanks
thanks
side stand pivot bearing removal help
- Thread starter jeff smith
- Start date
Always helpfull to add the month of production, 
they change things throughout the build year
two types of fixing , with top hats or without
sounds like the top hats are stuck, i cut mine of with a cold chisel and then replaced all
they change things throughout the build year
two types of fixing , with top hats or without
sounds like the top hats are stuck, i cut mine of with a cold chisel and then replaced all
FRAME AND MOUNTING PARTS Diagrams for BMW K25 (R 1200 GS) R 1200 GS 04 (0307,0317) | RealOEM.com
BMW parts K25 (R 1200 GS) R 1200 GS 04 (0307,0317) Diagram Selection
www.realoem.com
thanks for the reply its the steel bearing I cannot remove it rotates but must be off set due to wear still scratching my headAlways helpfull to add the month of production,
they change things throughout the build year
two types of fixing , with top hats or without
sounds like the top hats are stuck, i cut mine of with a cold chisel and then replaced all
FRAME AND MOUNTING PARTS Diagrams for BMW K25 (R 1200 GS) R 1200 GS 04 (0307,0317) | RealOEM.com
BMW parts K25 (R 1200 GS) R 1200 GS 04 (0307,0317) Diagram Selectionwww.realoem.com
Which part no, it been some time, but if you can point out which bit I'll have a chat to my friend who did it with me
FRA83131-1
Associated BMW part
46527683131
I may hacksaw the stand off and replace it if im unsucessful next week . thanks
Associated BMW part
46527683131
I may hacksaw the stand off and replace it if im unsucessful next week . thanks
The bush goes through the frame, it pushes in / out in a vertical or horizontal direction , it does not get pushed in / out like a pistion
If that makes sense , some say it has a hook hole in it to aid removal, bit i think i just levered mine out
The top hats will nip the bush if i recall, I had replacements just in case
If that makes sense , some say it has a hook hole in it to aid removal, bit i think i just levered mine out
The top hats will nip the bush if i recall, I had replacements just in case
Ignore the above, I finally got into the repair data,
Once the bolt is removed, the side stand will pull off
What will be stopping will be the top hats, or crud / build up which makes the gap to the other faces to small ,
I treated the top hats as a consumable, and snipped them/ cut them off
Once off the side stand can be levered off and the bearing drifted out.
Once the bolt is removed, the side stand will pull off
What will be stopping will be the top hats, or crud / build up which makes the gap to the other faces to small ,
I treated the top hats as a consumable, and snipped them/ cut them off
Once off the side stand can be levered off and the bearing drifted out.
Similar threads
