Im talking about the rev counter / speedo clocks. On my 08 GS there is a significant vibration when riding its very irritating, is it norma I have tightened the two bolts holding them in place but still vibrates
speedo shake
- Thread starter redhand
- Start date
Are the galvanised spring clips still there?
Post 78
http://www.ukgser.com/forums/showthread.php?352933-Clocks-stolen/page5&highlight=clocks+stolen
PS My clocks shake/move when riding
Post 78
http://www.ukgser.com/forums/showthread.php?352933-Clocks-stolen/page5&highlight=clocks+stolen
PS My clocks shake/move when riding
Gossy
Registered user
There are 3No. spring clips - are they ALL in place??
As above, check the three spring clips but also make sure the headlight is secure in the rubber bushing at the bottom and the two bolts either side are tight.
DesertStormer
Registered user
Mine shake from top to bottom too, predominantly at low revs.
tw99
Registered user
TADTS... Try looking at the road instead 
Bendy toy
Registered user
It can be very annoying if sunlight is being flashed in your face by the wobbly clock face.
Try new mounting rubbers or cut some rubber washers from cycle inner tube rubber to pad out the standard washers.
Going mad and jamming it solid is unlikely because the clips have go back on.
Sent from a widget that can't spell.
Try new mounting rubbers or cut some rubber washers from cycle inner tube rubber to pad out the standard washers.
Going mad and jamming it solid is unlikely because the clips have go back on.
Sent from a widget that can't spell.
Thanks lads stripped it down and put it back together. The problem appeared to bee the 2 bolts that the light pivots on not being able to tighten these enough. As the clocks are attached to the lights everything shakes. I will see tomorrow if its sny better when running
Similar threads
