Stud sheared

[lawvar]

Put on my new headers yesterday
And one if the rear bolts for the sump sheared off funny thing was i was tightening it lightly so think it had been overtightened before.
Got some pics as i thought the stud went into the engine block.
The stud comes out of a rubber mounting ?
Can you get these and how does it fit to the engine block ?

Sent from my SM-G920F using Tapatalk

 

[Mistacat]

It is just an anti vibration mount.
The studs are only mild steel so not very strong.
Using a spanner on the thin hex near the casing, unscrew it an fit a new mount.

 

[lawvar]

Thanks

 

[oldnfat]

Exactly the same happened to mine with very little effort at all....must have been shagged during manufacture.

 

[richtel]

The dealer puts copperslip in the sumpguard bolts each time it's removed.

 

[patzx12]

You can get a rubber anti-vibe mount in a good hardware shop and adapt it.

 

[Delboy777]

Here ya go http://www.ebay.co.uk/itm/4-x-Anti-...233537?hash=item33b30be601:g:eowAAOSwHPlWbxd3

 

[streaky]

The dealer puts copperslip in the sumpguard bolts each time it's removed.

You must have a good dealer

 

[Bendy toy]

If your spanner catches the engine paint (all too likely) smear the area with the same anti seize grease.

 

[lawvar]

Hi guys ordered it from bmw for £5 could have worse !

Sent from my SM-G920F using Tapatalk

 

[lawvar]

Here ya go http://www.ebay.co.uk/itm/4-x-Anti-...233537?hash=item33b30be601:g:eowAAOSwHPlWbxd3

Thanks for your help