I’ve ordered two Swingarm bearings, gearbox end, from motorworks. I thought they’d be bmw but are FAD. Do these require packing with bearing grease prior to fitting? If yes, do I pack both sides? I’ve not packed bearings before, but I presume I pop the outer seal off and pack it full - or half full then pop the seal back on?
I’ve removed my rusty bearings and like an idiot I didn’t make a note of which was the inner/outer side. Which is the inner ( facing into swingarm )?
I’ve removed my rusty bearings and like an idiot I didn’t make a note of which was the inner/outer side. Which is the inner ( facing into swingarm )?