Anyone happen to know what the torque setting is for the two main bolts on a gsa centre stand?????
Thanx in advance!
Thanx in advance!
torque setting on centre stand???
- Thread starter ghost-rider
- Start date
RTFM
a shade under kin tight...!
Main stand
It should be 40Nm
Prop
It should be 40Nm
Prop
Are you sure it's not a notch more??. .
Like "really tight". . .
a shade under kin tight...!
FT
As already said - 40nm.
Nice one lads, just what i needed to know
Fanum
Toubab
Nice one lads, just what i needed to know
Just make sure you put lots of copper slip on it first
Just make sure you put lots of copper slip on it first
...and if you do, don't use that torque figure
Bendy toy
Registered user
Coppa slip will increase the effective toeque so the wrench should be set lower. But Ive no idea how much lower.
As these do not all need to be accurately matched like engine bolts it makes more sense to do it by hand until you feel the threads go tight. Then stop. Any more and they will go loose again. It not difficult just common sense and dont be brutal with the spanner. Does anyone need a torque wrench for a bottle top?
As these do not all need to be accurately matched like engine bolts it makes more sense to do it by hand until you feel the threads go tight. Then stop. Any more and they will go loose again. It not difficult just common sense and dont be brutal with the spanner. Does anyone need a torque wrench for a bottle top?
Fanum
Toubab
Bendy toy
Registered user
Similar threads
