Voight risers

[Gyp]

Finally got round to sorting the wiring and fitting the Voight risers.

I test fitted them a while back and found that the wiring was too tight so slightly dislodged the throttle connector. Having recently discovered there was more slack in the loom than I'd realised, I've resolved that issue and fitted them again.

I did have the Wunderlich risers on which come up 20mm, however these come up and also come back which suits me better.

 

[EVskiy]

I am no mechanic, but I feel that gap wants to be of equal distance and fasteners torqued to correct value too.

 

[Gyp]

I am no mechanic, but I feel that gap wants to be of equal distance and fasteners torqued to correct value too.

Don't worry, on the 9T there's a gap at the back, and yes, everything is torqued up to spec


Have a look at https://voigt-mt.de/mediafiles/Sonstiges/v2523.pdf

 

[Baked Bean]

That is the correct way.

 

[EVskiy]

I am no mechanic, but I feel that gap wants to be of equal distance and fasteners torqued to correct value too.

View attachment 346213

Don't worry, on the 9T there's a gap at the back, and yes, everything is torqued up to spec


Have a look at https://voigt-mt.de/mediafiles/Sonstiges/v2523.pdf

That is the correct way.View attachment 346214

My apologies chaps!

 

[Gyp]

My apologies chaps!

You are one step closer to being a mechanic!

 

[Spook1969]

I wouldn’t be able to live with that gap either.

 

[OnHellas]

I wouldn’t be able to live with that gap either.

If you were looking at the gap whilst going along you’d soon have bigger issues to worry about

 

[Spook1969]

If you were looking at the gap whilst going along you’d soon have bigger issues to worry about