Warning Lights

[john_aero]

Ok, so start for start.

you turn ignition ok, all ok, thumb the starter and up she fires, great

hop on and rdrop down into 1st, great

then as move off you usually hear the few cluncks and elec noises as everything goes into place and the abs lights go off and on you go

but today, drop into 1st and off you go, no noise and abs lights flash on and off together. now they go away after while and then the abs warning lights flash but nto together.

so 1st warning is lights flashing both on off together what is this

2nd is abs warning lights flahsing, one on othe roff and vice versa. i was told this is low volt for the batetry.

but it just annoying.

 

[Sir James]

It means your going to be late for your own funeral because you forgot to fill up and got a toothbrush instead due to the double Nectar points ...

 

[john_aero]

oh also its a 2000 1150gs

 

[niko]

both together is normal before the clunk when you move off ,alternate flashing- abs not working ,try riding a few miles then stopping/restarting the engine (turn off on key) if it sorts its self its probably low volts (batt)

 

[john_aero]

did that

rode for last hour. stopped half way there, and when turnd back on still flashing but i didnt hear a clunk at anypoint as i normally do

 

[niko]

did that

rode for last hour. stopped half way there, and when turnd back on still flashing but i didnt hear a clunk at anypoint as i normally do

try resetting the abs ,if you look around theres a thread to tell you how

 

[john_aero]

cheers will do this.

front sensor looks bit dodgey as it got damaged when had forks off.

may have get new front one

 

[sockpuppet]

Find someone with a GS911 it should read the ABS fault code and tell you what the problem is.

 

[john_aero]

just plugged my own gs 9-11 in and only abs fault was dash light or something

cleared it and will take it for run later to see if still working