Ive now ordered a set (both high and low tones) from a 5 series off eBay.
I will just fit the low tone one for simplicity though.
Thanks again for all your responses.
S.
Or get a full akra system and never use your horn again.
The debate or the conclusion?And give up driving in the Alps and several countries in Europe. Especially in Austria and Germany where the debate on aftermarket cans is on the rise.
This morning my 5 series car horn (Low tone).
The only aspect i dont like about this mod is that the trumpet of the horn faces into the fairing and up towards the rider . . .
So I pre bought a bit of extension cable with the correct plug from a scrap yard.
I soldered (tinned) both wires of the extension wire and then jammed them into the bikes original socket..
The sealed it all with copious amounts of insulation tape. Because I have effectively lengthened the bikes wiring I can now mount the horn facing forwards and downwards towards the road (The sound does bounce off hard surfaces).
From a standing position the horn cannot be seen..
See photos..
P.S the soldered wires were and extremely tight fit.. I had to use 2 pairs of needle nosed pliers to insert into the holes of the original connector.
I actually own the Magnum horn. I had it on a previous bike.I have a Stebel Magnum (low) on my GSA. Available on eBay for just over £20
With a bit of jiggery pokery just about fits where the original horn goes and is a LOT louder than OE at 136DB.
No problem with the Canbus but it has spade connectors so you would have to buy an adapter from somewhere like NN or cut the original connector off and use a female spade connectors
Mike
Why is the picture upside down.....tried 4 times...never has this problem before
I actually own the Magnum horn. I had it on a previous bike.
Any links to the loom I'll need to fit to my 1250 GSA 2019?
Sent from my SM-G955F using Tapatalk
Thanks Mike, No problem at all. . I'd seen that loom and thought it looked correct. Any issues mounting the horn? Had a quick look and it seems a bit tight for space.
Thanks Mike, No problem at all. . I'd seen that loom and thought it looked correct. Any issues mounting the horn? Had a quick look and it seems a bit tight for space.
Sent from my SM-G955F using Tapatalk