2006 GSA cuts out when turning handlebars to right

[Gaz1967]

Hi all,

I am know nothing about electrics, so please go easy.

I went to get a new set of tyres & for the 1st time (had the bike 2 years & done 4k) it cut out each time i tuned the handlebars both left & right. I removed the tie-wraps holding the harness that leads to both grips & it appears that if I wiggle the harness at the point where the 2 parts meet close to the top of the front shock this causes the issue.

Its such a tight spot i am scratching my head as to what to do. I have had new aftermarket Micron shocks fitted front & back over last winter.

Can any of you guys offer any advise.

Thanks,

Gaz

 

[g.s.john]

Check the wiring from the ignition to the harness probably a broken wire also the multi plug on the harness.

 

[Andy63]

Common fault chase the cables from the ignition barrel down into the headstock unwrapping the loom tape, you will most probably find a tight cable tie thats holding the loom generally find a broken wire somewhere near it.

 

[Old Codger]

Wiring to the ignition switch from the harness a fair bet. Don’t know if it’s a short set of replacement wiring like the 1150,s . They were an easy repair . Broken wire in there needs finding.

 

[NicD]

there's a cable tie under the ignition - it's the first one that holds ignition harness to the frame. It's common for one of the wires to break here and produce intermittent fault. Had it myself. Simple fix