I've noticed that my left hand grip is slightly loose. Moves a couple of mm back and forward. Can it be tightened? can only see some tiny screw heads which I don't think will nip it up.
bar grips
- Thread starter kwallace21
- Start date
bikemad
Registered user
You'll have to put up with it if you have slightly elongated holes that'll be the problem,suppose you could put some electrical tape under it might do the trick ?
Bendy toy
Registered user
It's bolted to the handlebar with an itty bitty little screw that also stops the switchgear from moving. Is the clutch lever hitting anything it shouldn't?
Lever isn't hitting anything. I saw the two tiny torx screws at the back but didn't think it was those that held it on. I didn't want to over tighten them as they are so small.
Similar threads
