Ignition stitched feed

[karlp]

Anyone know if there is an ignition switched 12v supply near the ECU.

I know thy there is a socket near the front of the bike but trying to save me putting a wire from middle to front.

 

[Wapping]

Not sure where the ECU sits, I'm afraid.

Could you tap into an early part of the rear light feed?

Not of course the rear brake light feed, as I once did

Does the model still have the under the seat auxiliary socket? If so, that might do the trick, perhaps?

 

[roadrider]

Under the seat where the 2 fuses are. True switched live. can't remember the colour but there's only 2 wires anyhow.

 

[karlp]

Not sure where the ECU sits, I'm afraid.

Could you tap into an early part of the rear light feed?

Not of course the rear brake light feed, as I once did



Does the model still have the under the seat auxiliary socket? If so, that might do the trick, perhaps?

Hi

ECU sits immediately under the seat so I have put this super duper fuse box on top, but I need a feed.

Cannot use the rear light/ brake feed as they are now 5v ( being LED)

and

No rear auxiliary socket

I could find one by measuring voltages etc but would rather work with knowledge rather than just go bull at a gate.

Dealer says run a wire from the front auxiliary socket but that is a bit of a pain

Karl

 

[karlp]

Under the seat where the 2 fuses are. True switched live. can't remember the colour but there's only 2 wires anyhow.

I have seen those two wires, in a sort of plastic pouch.

Thanks

karl

 

[roadrider]

I have seen those two wires, in a sort of plastic pouch.

Thanks

karl

That's them, I used the 7.5 amp

 

[batman1]

Under the seat where the 2 fuses are. True switched live. can't remember the colour but there's only 2 wires anyhow.

Yep that's correct!
I think that it is the one with the thin blue trace, but I suggest that you double check with a meter!