Intraride fitting

[THE ROVER]

Hello, I have just ordered the intraride rp1 duo and will hopefully have a go at fitting it this weekend.
Anyone have any knowledge of where best to put it on a adv as although the staff where helpful they did'nt know about this. Was thinking of putting it either near to the battery under the tank or where the toolkit goes as I could carry that in the tankbag if need be. Cheers Stuart

 

[PeterGS]

I emptyed the tool tray and found that the Intraride radio and main box would fit side by side provided I removed a couple of the tool holding lugs.
The tray can then be reused for the tools when I sell it.

The tray just needed 'modifying' slightly on the front edge to allow the wires to reach the fuses and the front of the bike. Both of the headset cables also pass through the holes I made in the tray front and can be pursuaded to lay in the metal 'tray' between the seats. Appears to work o/k.

 

[ianboydsnr]

if you don't use it all the time, you could leave it in your tank bag

 

[ianboydsnr]

mines in place of the tool bag, its on a fazer 1000, so thats not much help

 

[oblertone]

RP1

I have an Intaride RP1 and it sit's nicely on top of the Air Filter housing on my 1100. I have the PMR radio up front between the screen and clocks, but you do need to take the tank off to route the wires.