New to me R1100GS
- Thread starter nicholsonj2252
- Start date
Yes - no problem at all . Heat them to cherry red with an Oxy Acetylene torch . New nuts and exhaust gaskets on order for when I re-assembleYou got the header bolts out then
Getting there , new brake lines all fitted and brake system bled . Full service done . Upper fixing for rear splash guard was snapped off so have fitted a Motorworks delete cover for that . Bike is reasonably tidy cosmetically for its age , centre stand and rocker covers would benefit from a powder coat and perhaps a few stainless bolts to replace some corroded OEM ones . It needs new inner rocker cover gaskets (donuts) as one was damaged and is weeping oil slightly , I've ordered a new pair and will fit them and the black plastic head guards once received . Sump guard still to refit and then get some new tyres fitted . Hopefully get it all done and MOT'd this week
New rubber getting fitted today
What a great bike for someone, it'll just run and run...for the price of 12mths PCP
Well just when I thought I was finished , came to fit the new rocker cover gaskets and of the 8 rocker cover bolts , 4 of them have stripped threads on the cylinder head - explains why silicon sealant had been used on the old gaskets . Need to fit helicoils so will have to remove the heads to ensure the drilling is accurate . £100 delivered for a pair of head gaskets !! The last one's I bought for a R100 were £10 each
I made a jig last time a lot cheaper than head gaskets 
Got any details ? I did think at £100 for gaskets it may be worrh seeing if i could get a drilling guideI made a jig last time a lot cheaper than head gaskets
It was just a bit of steel my friend had in his workshop about 75mm x 50mm x 30mm thick
I got him to face it flat on both sides and mill it to an L shape and round the outer corners particularly the Inner L part
I then guestimated roughly where a guide hole could be used on all 4 corners if I moved the block around
Because it was such a small drill and soft material I just had to hold it in place against the face get the drill in place and make sure the bottom was flat on the head faces and drill slowly trying to makes sure it did not grab
It worked okay but in reality it was only getting used for a few seconds as I was only drilling in about 10 ~12 mm for 1.5xD coils
Thanks Jay , I’ve just got hold of a drill guide so will do something similar 
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Similar threads
