Ollie GBR
Registered user
Tomorrow I'll be adding the wiring to my Fog lights from TT. While I'm at it I'll be upgrading them to Les's HID's. I have my own handle bar switch and will be butchering the TT supplied wiring to match my preferred setup.
According to the TT instructions, I'm required to tap into the low beam wire for the solenoid switch. [Which is a bit of a pain in the a**]
Are there alternatives? I just need a ignition switched source, can I tap into the BMW diagnostic's green with blue stripped wire? [Worried about warranty issues
]
I'm planning to have the solenoid under the tool tray, near the battery.
Cheers
Ollie
According to the TT instructions, I'm required to tap into the low beam wire for the solenoid switch. [Which is a bit of a pain in the a**]
Are there alternatives? I just need a ignition switched source, can I tap into the BMW diagnostic's green with blue stripped wire? [Worried about warranty issues
]I'm planning to have the solenoid under the tool tray, near the battery.
Cheers
Ollie

