Quiet outgoing - Autocom 300 / Zumo 660 / 1273

Have PM'ed Rich - but in case anyone else can help....
not dissimilar to http://www.ukgser.com/forums/showthread.php?t=200617
=========================

I have installed the Autocom - works great for radio and pillion

Connected Zumo 660 with cable - great for nav and mp3

Connected phone to Zumo - can see all of my contacts and make calls on Zumo screen etc - but VERY quiet outging - I can hear them...
was told to get a 1273 and have
Phone on BT to Zumo & Zumo on BT to 1273 (plugged into aux 1) - set up as Audio on Zumo 660

I have done all except I cannot pair the 1273 with the Zumo...
When I hold down the button I can turn it off or flashing
Off - doesn't show on Zumo - flashing does.Keeps telling me incorrect passcode.
I am using http://www.autocom.co.uk/pdf/Part 1273 Bluetooth Adaptor.pdf as instructions

Can you help?

autocom 300 & zumo 660 & phone

Just came back from Warwick where Rich sorted my porblem out, mine was more like my Nokia N95 was too loud.

my set up

Zumo 660 connected via part 1314 isolated music lead, so this would run from the Zumo into the AUX2 socket on your Super Pro.

There is no need to connect the zumo mic to the autocom.

Nokia N95 bluetoothed to the Zumo.

Part 1273 bluetooth dongle plugged into aux 1 - set up as Audio on Zumo 660

to pair

after turning on the bike wait about 10-20 sec for the dongle to initilise.

hold the botton down on the dongle until the light goes out
release button.

press button & hold until light flashes like buggery.

On zumo blue tooth pair the audio, entering 0000 when needed. identified as autocom bluetooth dongle


the trick for me was waiting for the bluetooth dongle to initialise and be receptive to pair.

make sure no other blue tooth is trying to pair with the dongle.


you did not mention what type of phone you had.

good luck

HTC Diamond Touch
But also have a Nokia "business phone" cant remeber model - much simpler phone - may be better....

Will try waiting a bit longer before trying to pair with 1273....

Is part 1314 just a 2 pole isolated lead then?

PM replied to

Rich