For those who use Wanderlust - apparently it doesn't work with Mapsource 6.14
Copied from the Wanderlust forum
"Garmin's new : City Navigator Europe NT 2009, Deluxe All Regions, Aug. 08
Once downloaded, ( 2.45 Gb) this version will install itself on your PC and install Map Source 6.14 automatically overwriting any previously installed Map Source versions. City Navigator Europe NT 2009 will ONLY work under 6.14
If you use Map Source 6.13.7 or lower, you will not be able to see the maps on your PC
I use the marine unit ( which also can do auto routing) the GPS 278C which has sufficient internal memory to upload all of these and hold them and I was able to update my unit only.
I spoke to Garmin who were very helpful but advised me there is no way around it as their software has been designed around 6.14
You currently cannot use the SmellyBiker's fab V2 maps under Map Source 6.14 - only 6.13 at present - Bob is aware of this and looking into it.
This is the same problem for other non-Garmin maps many of us use."
Copied from the Wanderlust forum
"Garmin's new : City Navigator Europe NT 2009, Deluxe All Regions, Aug. 08
Once downloaded, ( 2.45 Gb) this version will install itself on your PC and install Map Source 6.14 automatically overwriting any previously installed Map Source versions. City Navigator Europe NT 2009 will ONLY work under 6.14
If you use Map Source 6.13.7 or lower, you will not be able to see the maps on your PC
I use the marine unit ( which also can do auto routing) the GPS 278C which has sufficient internal memory to upload all of these and hold them and I was able to update my unit only.
I spoke to Garmin who were very helpful but advised me there is no way around it as their software has been designed around 6.14
You currently cannot use the SmellyBiker's fab V2 maps under Map Source 6.14 - only 6.13 at present - Bob is aware of this and looking into it.
This is the same problem for other non-Garmin maps many of us use."
In short, frustrating.
