deaninkl
Registered user
A while back I was in the middle of nowwhere, a good 300km from the nearest tyer designed for a 1200 GS when I got a 2 inch gash in my rear tyre. After a lot of phoning around I found a Michlin Macadum the correct size and had it sent by van to where I was. The michlin was serving me well, and was a very good road tyer for the GS.
With a good 3-4mm of center tread left, it today decided to let go of a chunk of tyre tread a good 3 x 2 inches in size...I was on a good surface, so can only assume the tyre must have been old when I first fitted it. I was 40km from my destination so carried on slowly without a problem, just a slight vibration at certain speads.
On further inspection I found a couple of other suspect patches, but no further deteriation. I'm a long way from any city, and 300km from the nearest dealer with a tyer the correct size for my GS. I'm temped to drive slowly home, as attempts to have a tyer sent here have so far not worked (I'm a few hundred KM north west of Kuala Lumpur, the nearest city with Battlewings.
Anybody had to do serious miles on fecked tyers? any thoughts?
Cheers.
With a good 3-4mm of center tread left, it today decided to let go of a chunk of tyre tread a good 3 x 2 inches in size...I was on a good surface, so can only assume the tyre must have been old when I first fitted it. I was 40km from my destination so carried on slowly without a problem, just a slight vibration at certain speads.
On further inspection I found a couple of other suspect patches, but no further deteriation. I'm a long way from any city, and 300km from the nearest dealer with a tyer the correct size for my GS. I'm temped to drive slowly home, as attempts to have a tyer sent here have so far not worked (I'm a few hundred KM north west of Kuala Lumpur, the nearest city with Battlewings.
Anybody had to do serious miles on fecked tyers? any thoughts?
Cheers.



