Tuning Chip Instructions

Rugged Path

The Honourable.
UKGSer Subscriber
Joined
Jul 23, 2004
Messages
2,370
Reaction score
123
Location
Wybunbury, Cheshire East, England, EU
I bought a chip for my 2003 1150GS Adv. a long time ago and was waiting for the day I would buy a livlier exhaust system before installing it, That day has arrived care of 'ebay' and will now fit it all on.

Unfortunately, I cannot find the instructions for installing the chip so, could someone please pm me a copy?

Thanks
 
It's simple, remove tank, disconnect battery, remove connector from ECU and then remove ECU from bike.
Remove security screws from ECU top cover, insert sharp knife and work around the joint to cut through silicone sealant holding ECU together.
Remove clip and lift out old chip then carefully insert new chip (you will probably have to bent the legs of the new chip a little until they line up with the holder on the circuit board)
Fit new chip and replace clip, apply new sealant and reverse disassembly procedure, don't forget to check throttle cables are properly seated into throttle bodies before starting up.

Enjoy!:thumb2
 


Back
Top Bottom